Tungsten CoG Weights^™

Description

Fine-tune your car's Center of Gravity (CoG) and optimize performance and stability. Includes four 1/2 oz (14.1 g) screw-in Tungsten CoG Weights^™. Use weights individually or as 2 to 4-unit sets. Screw-in and adjust with an Allen wrench.

Weights are 3/4" in length, tip to tip, and 3/8" in diameter. Use a 23/64" size drill bit when drilling a hole for weights in the car body.

Safety Warning

WARNING: Choking Hazard!

Small parts. Not intended for children under 3 years. Adult supervision required.

AVERTISSEMENT: Danger d’étranglement! Petites pièces. Pas recommandé pour les enfants de moins

de 3 ans. Supervision d’un adulte requise.

• I purchased the P362 Funnycar Pre-Cut Design car body and I do not want to place the weigths on the bottom of the car. Could I drill holes in the rear of the car and insert weights there? If so, how many weights would I need?

  Yes, holes can be drilled into the rear of the Funnycar Pre-Cut Design. Round Weights (P350) and Tungsten Cylinder Weights (P3914, P3915) fit a 3/8" cavity and Tungsten CoG Weights (P3918, P3919) fit a 23/64" cavity. The amount of weight needed will depend on your local race rules.

• I am looking at your Stealth car and wondering if the weights fit in the holes drilled in the back. What weights do I need?

  Yes. The holes drilled in the rear of the car accept cylindrical weights that fit a 3/8” cavity. We have several weights that can be used with this racer. Round Weights, Tungsten Cylinder Weights, and Tungsten CoG Weights.

   

• What is the thread size of the Tungsten CoG Weights?

  Tungsten CoG Weights thread size is 3/8-16.