We do not manufacture plastic screws and have never tested their usage. This is how we recommend you attach track to your Track-Bed.
We recommend using Foam Tack Glue. Sand surface of Track-Bed with 120-grit sandpaper, then spread a thin layer of glue over the Track-Bed surface and install track. Pin in place with Foam Nails while drying.
Click here to view a video on installing Track-Bed.
Model Scales
G = 1:24
O = 1:48
S = 1:64
OO = 1:76.2
HO = 1:87
N = 1:160
Z = 1:220
Use the Just Plug Light Block Kit. Apply Masking Paint to interior walls to keep the building from glowing. Press the included Ribbon Putty into interior corners, joints, and along the bottom edges of structures to seal the seams.
Click here to see a video on using the Light Block Kit to prevent glow.
Model Scales
G = 1:24
O = 1:48
S = 1:64
OO = 1:76.2
HO = 1:87
N = 1:160
Z = 1:220
Yes, you can.
The rated output for the Power Supply is 1000 milliamps (mA). To determine the total number of Just Plug LED Lights the Power Supply can support, add up the milliamps of each LED Light being used. The milliamps are listed on the light packages. Total number of milliamps should not exceed 1000mA per Power Supply. If 1000mA is exceeded, the Power Supply's non-replaceable thermal fuse will be overloaded.
We have created grade crossing signals with Red Flashing LED Nano Lights. Run and glue the LED wire alongside the pole and crossing bar. Drill a hole through the bar and light fixture large enough for the Nano Light to fit through and super glue it in place. Camouflage the wire by painting it the same color as the pole and crossing bar.
There are many different types of grade crossing signals. We cannot guarantee this technique will work for your particular signal.
Click here to view a video about the Auxiliary Switch and port control.