Mix a tiny amount of fine, iridescent glitter with Snow Flake Snow™ until the desired look is achieved, keeping in mind that a little goes a long way. Spray an already modeled snow base with Scenic Cement™ and apply the mixture while glue is wet.
You can also mix glitter with Water Effects™ before modeling icicles.
Yes, as long as the Water Effects is fully cured.
Yes. Allow Water Effects to cure completely before applying Water Waves.
You can clean tools and brushes with warm soapy water.
Yes, it can be painted after it is dry with 100% acrylic paint.
Depending on how thick Water Effects was applied, it could take quite a few days for it to dry completely clear.
To speed up dry time, place a fan near the diorama to better circulate the air in the room.
Both products are water-soluble. Clean brushes immediately with warm, soapy water.
General cleaning information is listed on the label in the Modeling and Care Information.
You can make any size waterfall you want with Water Effects™ (C1212). To view a step-by-step video, visit the following link: http://woodlandscenics.woodlandscenics.com/show/video/MakeWaterfall
Water Effects is moldable, holds its shape and dries clear. To model moving water, apply on top of dried Realistic Water™ or E-Z Water with a paintbrush or craft stick.To model a waterfall, squeeze onto freezer paper or non-stick pan in desired shape and length (add 1/2” to length for attaching to layout). Let dry until clear, then peel off surface carefully and attach using Water Effects as an adhesive. Dry time varies due to heat and humidity.
You can use our Water Tint which is specially formulated to tint Deep Pour Water, Realistic Water and Surface Water. Or you can mix a small amount of Earth Colors® Liquid Pigment or water-soluble paint into Water Effects™ before applying.
Water Effects will remain pliable. Anything set on top of it will stick to it and leave indentations.
Yes, you can thin out Water Effects™ with a little water. Make sure to test a small area first to be sure you have the correct consistency for the application intended.
An 8 fluid ounce bottle of Water Effects™ covers approximately 627 square inches when applied 3/32" thick. Actual coverage depends on application.
The 24-hour dry time of Water Effects is a guideline only. Actual dry time depends on a number of factors. Very thick applications could take a couple of weeks to clear completely. Environmental conditions like heat and humidity could also extend dry time. To speed up dry time, place a fan in the room to circulate the air.
This method makes very realistic ice blocks. Adjust size accordingly.
1. Apply a square layer of Water Effects onto a non-stick surface, such as freezer paper or a non-stick pan. Let dry until clear. 2. Add additional layers as needed, letting each layer cure fully. 3. If necessary, trim with hobby knife after blocks are cured and clear.