Research the era and the geographic area you are modeling for the correct standards.
Modern lane lines are generally 4-inches wide. This includes road, highway, and parking lot lines in white (solid and dashed) and yellow (single, double, solid and dashed). N Scale: 4” = 0.025 / Decal: 1/32”
HO Scale: 4” = 0.046 / Decal: 3/64”O Scale: Place two 3/64" decals side-by-side
Our Model Graphics – Stripes are approximately 7-1/2 inches in length. The number of packages needed will depend on your chosen scale and length of road.
Here are the size and quantity per package.
Size # of pcs
0.01 12 pcs
1/64 11 pcs
0.22 12 pcs
1/32 8 pcs
3/64 8 pcs
To make road stripping easy, we recommend using Road Striping Pens in White or Yellow and the Flexi Edge road striping guide. When the Road Striping Pens are applied onto Top Coat Asphalt or Concrete, mistakes are easily removed with the Road Stripe Remover.
We recommend using a brush-on, water-based clear gloss.
Sprays contain a propellant that is usually solvent-based. Solvents have been known to eat away at decals. We recommend using the brush-on acrylic gloss varnish. Apply to a small, test area first to check for compatibility.
The best method we have found for removing dry transfer decals is to press a piece of clear tape onto the decal, rub with a burnisher or dull pencil, and then peel off the tape. The Dry Transfer should come off fairly easily, but it may take a couple of applications to remove it all. If there are spots of decal remaining, soak a cotton swab in denatured or isopropyl alcohol and rub over the decal. The remainder will come off easily.