We recommend using Foam Tack Glue (ST1444) to attach Track-Bed to a layout.
There are different application methods depending on base material.
Plaster surfaces: Spread a thin, even layer of Foam Tack Glue where Track-Bed will be installed. Lay Track-Bed and pin in place with Foam Nails (ST1432) to secure while drying. Work in two to three-foot sections. This application method also allows the modeler to make adjustments while installing Track-Bed.
A permanent application method for plaster and other surfaces: Use the Contact Gluing Method. Apply Foam Tack Glue to both contact surfaces. Let dry until clear and tacky (maximum working time is 1 hour), and then press Track-Bed in place. Installation of Track-Bed has to be precise, because glue will bond instantly. Place Track-Bed in manageable sections.
For both application methods, we recommend sanding the top and bottom surface of Track-Bed with 120-grit sandpaper before installation.
We do not manufacture plastic screws and have never tested their usage. This is how we recommend you attach track to your Track-Bed.We recommend using Foam Tack Glue (ST1444). Sand surface of Track-Bed with 120-grit sandpaper, then spread a thin layer of glue over the Track-Bed surface and install track. Pin in place with Foam Nails (ST1432) while drying.